Predefined user roles
network-admin
network-operator
Parameters
inbound: Displays inbound traffic rate statistics.
outbound: Displays outbound traffic rate statistics.
interface-type: Specifies an interface type.
interface-number: Specifies an interface number.
Usage guidelines
The statistics cover only interfaces in up state.
If an interface type is specified, the command displays traffic rate statistics for all up interfaces of the
specified type over the last statistics polling interval.
If no interface type is specified, the command displays traffic rate statistics for all up interfaces that have
traffic counters over the last statistics polling interval.
If an interface which is always down over the last statistics polling interval is specified, the system prompts
that the interface does not support the command.
You can use the flow-interval command to set the statistics polling interval.
Examples
# Display the inbound traffic rate statistics for all Ten-GigabitEthernet interfaces.
<Sysname> display counters rate inbound interface ten-gigabitethernet
Interface
XGE1/0/15
XGE1/0/27
Overflow: More than 14 digits.
--: Not supported.
Table 2 Command output
Field
Interface
Total (pkts/sec)
Broadcast (pkts/sec)
Multicast (pkts/sec)
Overflow: more than 14
decimal digits
--: not supported
Related commands
flow-interval
•
Total (pps)
Broadcast (pps)
0
0
Description
Abbreviated interface name.
Average rate (in pps) of receiving or sending packets during the statistics
polling interval.
Average rate (in pps) of receiving or sending broadcast packets during the
statistics polling interval.
Average rate (in pps) of receiving or sending multicast packets during the
statistics polling interval.
The command displays Overflow if the data length of a statistical item is
greater than 14 decimal digits.
The statistical item is not supported.
5
--
--
Multicast (pps)
--
--