Default
The hello time is 200 centiseconds.
Views
System view
Predefined user roles
network-admin
Parameters
time: Sets the hello time in centiseconds, in the range of 100 to 1000 in increments of 100 (as in 100,
200, 300).
Usage guidelines
Hello time is the time interval at which spanning tree devices send configuration BPDUs to maintain the
spanning tree. If a device fails to receive configuration BPDUs within the set period of time, a new
spanning tree calculation process is triggered due to timeout.
HP recommends not setting the hello time with this command. Instead, you can specify the network
diameter of the switched network by using the stp bridge-diameter command and let the spanning tree
protocols automatically calculate the optimal settings for the hello timer. If the network diameter uses the
default value, the hello timer also uses the default value.
Examples
# In MSTP mode, set the hello time to 400 centiseconds.
<Sysname> system-view
[Sysname] stp timer hello 400
Related commands
stp bridge-diameter
•
stp timer forward-delay
•
stp timer max-age
•
stp timer max-age
Use stp timer max-age to set the max age timer of the device.
Use undo stp timer max-age to restore the default.
Syntax
stp timer max-age time
undo stp timer max-age
Default
The max age is 2000 centiseconds.
Views
System view
Predefined user roles
network-admin
132