HP 5900 series Command Reference Manual: Stp Port Priority

Layer 2 - lan switching.
Hide thumbs

Advertisement

When the setting is configured in Ethernet interface view, it takes effect on only that interface.
When the setting is configured in aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
Examples
# Configure the link that connects Ten-GigabitEthernet 1/0/3 as a point-to-point link.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/3
[Sysname-Ten-GigabitEthernet1/0/3] stp point-to-point force-true
Related commands
display stp

stp port priority

Use stp port priority to set the priority of the ports. Port priority affects the role of a port in a spanning
tree.
Use undo stp port priority to restore the default.
Syntax
stp [ instance instance-list ] port priority priority
undo stp [ instance instance-list ] port priority
Default
The port priority is 128.
Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
instance instance-list: Sets the priority of the ports in the MSTIs that are specified by an instance list, in the
format of instance-list = { instance-id [ to instance-id ] }&<1- 1 0>, where &<1- 1 0> indicates that you can
specify up to 10 instances or instance ranges. The instance-id argument ranges from 0 to 4094, and the
value 0 represents the CIST.
priority: Specifies the port priority in the range of 0 to 240 in increments of 16 (as in 0, 16, 32).
Usage guidelines
The smaller the value, the higher the port priority. If all ports on your device use the same priority value,
the port priority depends on the port index. The smaller the index, the higher the priority.
When the setting is configured in Ethernet interface view, it takes effect on only that interface.
When the setting is configured in aggregate interface view, it takes effect on only the aggregate
interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after the
port leaves the aggregation group.
123

Advertisement

This manual also for:

5920 series

Comments to this Manuals

Symbols: 0
Latest comments: