The load sharing criteria that you configure will overwrite the previous criteria.
If unsupported load sharing criteria are configured, an error prompt will appear.
In system view, the switch supports the following load-sharing criteria and combinations:
•
Load-sharing criteria automatically determined based on the packet type
Source IP address
•
Destination IP address
•
Source MAC address
•
Destination MAC address
•
•
Source IP address and destination IP address
Source IP address and source port
•
Destination IP address and destination port
•
Source IP address, source port, destination IP address, and destination port
•
Any combination of incoming port, source MAC address, and destination MAC address
•
Examples
# Configure the destination MAC address as the global link-aggregation load sharing criterion.
<Sysname> system-view
[Sysname] link-aggregation global load-sharing mode destination-mac
Related commands
link-aggregation load-sharing mode
link-aggregation lacp traffic-redirect-notification enable
Use link-aggregation lacp traffic-redirect-notification enable to enable link-aggregation traffic
redirection.
Use undo link-aggregation lacp traffic-redirect-notification enable to disable link-aggregation traffic
redirection.
Syntax
link-aggregation lacp traffic-redirect-notification enable
undo link-aggregation lacp traffic-redirect-notification enable
Default
Link-aggregation traffic redirection is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
With this feature, when you shut down a Selected port in an aggregation group, traffic can be redirected
to other Selected ports.
With this feature, when you restart an IRF member device that contains Selected ports, traffic can be
redirected to other IRF member devices.
81