Mac-Address Multiport (System View) - HP 5900 series Command Reference Manual

Views
Ethernet interface view, aggregate interface view
Predefined user roles
network-admin
Parameters
mac-address: Specifies a unicast MAC address in H-H-H format, excluding multicast and all-zero MAC
addresses. When entering a MAC address, you can omit the leading zeros in each H section. For
example, enter f-e2- 1 for 000f-00e2-0001.
vlan vlan-id: Specifies an existing VLAN to which the interface belongs. The value range for the vlan-id
argument is 1 to 4094.
Usage guidelines
A multiport unicast MAC address entry is used to repeat frames with a specific destination MAC address
out of multiple ports.
Examples
# Add a multiport unicast MAC address entry for MAC address 0001-0001-0101 on interface
Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 that belong to VLAN 2.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] mac-address multiport 0001-0001-0101 vlan 2
[Sysname-Ten-GigabitEthernet1/0/1] quit
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mac-address multiport 0001-0001-0101 vlan 2
Related commands
• display mac-address multiport

mac-address multiport (system view)

•
mac-address multiport (system view)
Use mac-address multiport to add the specified interfaces to a multiport unicast MAC address entry.
Use undo mac-address multiport to remove the specified interfaces from a multiport unicast MAC
address entry.
Use undo mac-address to remove a multiport unicast MAC address entry.
Syntax
mac-address multiport mac-address interface interface-list vlan vlan-id
undo mac-address multiport mac-address interface interface-list vlan vlan-id
undo mac-address [ multiport ] [ [ mac-address ] vlan vlan-id ]
Default
No multiport unicast MAC address entry is configured.
Views
System view
59