Show Arpentry - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Success.
DGS-3620-28PC:admin#
7-4 config arpentry force_aging_addr
Description
This command is used to to configure the force aging gateway address in the ARP table.
Format
config arpentry force_aging_addr [add | delete] <ipaddr>
Parameters
add - Specifies to add a new entry.
delete - Specifies to remove an existing entry.
<ipaddr> - Enter the IP address of the gateway here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example shows how to add a force aging ARP entry of gateway10.48.74.12.
DGS-3620-28PC:admin#config arpentry force_aging_addr add 10.48.74.12
Command: config arpentry force_aging_addr add 10.48.74.12
Success.
DGS-3620-28PC:admin#
7-5

show arpentry

Description
This command is used to display the Address Resolution Protocol (ARP) table. Filter the display by
IP address, interface name, static entries or mac_address.
Format
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static | mac_address <macaddr>}
Parameters
ipif - The name of the IP interface the end node or station for which the ARP table entry was
made, resides on.
<ipif_name 12> - Enter the IP interface name. The maximum length is 12 characters.
149