Configuring The Hardware In The Rack - Avaya S8700 Installing Manual

22 Installing the Avaya™ S8700 Media Server with Avaya™ G600 Media Gateway

Configuring the Hardware in the Rack

Configuring the Hardware in the
Rack
After you have installed all the hardware in the rack, you must configure the components and
connect them together.
This section covers the following tasks:
''Configure Media Server 1'' on page 24
•
• ''Connect Duplication Cables'' on page 40
''Configure Media Server 2'' on page 41
•
''Connect UPS Ethernet Cables to Ethernet Switch'' on page 48
•
• ''Configure the SNMP Modules in the UPSs'' on page 49
''Configure the SNMP Subagent in the Avaya Ethernet Switch (if used)'' on page 52
•
Once the hardware is installed you must upgrade the software on the two media servers,
configure them, install the license and Avaya authentication files, and test the connectivity to
the customer's network. You upgrade and configure the first media server, verify its operation,
then upgrade and configure the second media server and verify its operation.
May 2003