Restoring Default Settings - Psion Teklogix Omnii XT10 User Manual

Appendix C: Bar Code Settings

Restoring Default Settings

Note: Your Omnii comes preconfigured from the factory for internal scanner types. The
type of scanner installed can be determined from the System icon in the Control
Panel, under the System Properties tab.
Important: To improve the decode speed and performance, enable (set to 'on') only
Keep in mind that some bar code types are only available when an internal imaging scanner
is installed. All internal scanners can be configured using these dialog boxes.
C.1.2

Restoring Default Settings

If you want to restore the factory defaults after making changes, the defaults can be applied
to a selected parameter, sub-tree of parameters, or all scanner parameters.
• Press and hold on a symbology (e.g., Code 128) to display a pop up a menu.
• Choose Default subtree to reset only the parameters in the symbology you selected, or
choose Default all settings to reset all scanner parameters to default settings.
To reset a single parameter to its default setting:
• Press and hold on the parameter you want to reset.
C-6 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
those codes that are required by the application.