Upc A; Ean 13; Ean 8; C.3.5 Ean 13 - Psion Teklogix Omnii XT10 User Manual

Appendix C: Bar Code Settings
Decoded (Intermec ISCP)

EAN 13

C.3.5 EAN 13
Enabled
Set this parameter to on to enable "EAN 13".
ISBN Conversion
When this parameter (International Standard Book Number) is enabled, the first 3 characters
('978') are ignored and the checksum (0.9, 'X') is calculated on the remaining characters.
Transmit Check Digit
If the check digit is to be transmitted with the data, this parameter must be enabled.
Add/Remove Data
Refer to "Add/Remove Data" on page C-14 for details.
C.3.6

EAN 8

Enabled
Set this parameter to on to enable "EAN 8".
Transmit Check Digit
If the check digit is to be transmitted with the data, this parameter must be enabled.
Convert To EAN 13
If this parameter is enabled, an EAN 8 bar code is converted to EAN 13.
Add/Remove Data
Refer to "Add/Remove Data" on page C-14 for details.
C.3.7

UPC A

Enabled
Set this parameter to on to enable "UPC A" bar code scanning recognition.
Transmit Check Digit
If the check digit is to be transmitted with the data, this parameter must be enabled.
C-30 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual