After unpacking your unit:
•
Visually inspect the charger for possible damage.
•
Install the IEC power cord and apply power.
6.5.4
Operator Controls
Omnii docking stations and chargers have no operator controls.
6.5.5
Power Consumption Considerations
Check to ensure the mains circuit supplying chargers and/or docking stations is adequate for
the load, especially if several chargers and docking stations are being powered from the
same circuit.
6.6
Power Adaptor Options
The following adaptors can be ordered for your Omnii:
AC Wall Adaptor
Vehicle Power Outlet Adaptor
Snap Module – Power/Charger Only
Snap Module – USB Host/Client plus Power/Charger
Snap Module – USB DE9M powered serial plus Charger
6.6.1
Snap Modules
The Snap Module is a mobile power adaptor for Omnii. The Snap Module is compatible
with the AC Wall Adaptor and the Vehicle Power Outlet Adaptor.
Three types of Snap Modules are available:
•
Model No. ST3101 (Charger only variant): powers and charges the hand-held.
•
Model No. ST4001 (USB Host/Client variant): powers and charges the hand-held. It
provides communications via USB 1.1/2.0 Host and USB 2.0 Client connectors and
provides a DC IN port. When attached to Omnii, it allows ActiveSync connectivity with
your PC, connection to an AC wall adaptor (Model No. ST1050) or a Vehicle Power
Outlet Adaptor (Model No. ST3113), and the use of a micro-USB to USB 'A' cable
(Model No. PX3058).
Adaptor Description
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Chapter 6: Peripheral Devices & Accessories
Operator Controls
Model Number
ST1050
ST3113
ST3101
ST4001
ST4005
177