Telepen; Gs1 Databar; D.5.17 Discrete 2 Of 5 - Psion Teklogix Omnii XT10 User Manual

Appendix D: Teklogix Imagers Applet
Bar Code Symbologies – Descriptions
Discrete 2 of 5
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 48.

D.5.17 Discrete 2 of 5

Enabled
Set this parameter to on to enable "Discrete 2 of 5".
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 48.
D.5.18 Telepen
Enabled
Set this parameter to on to enable "Telepen".
Enable AIM Output
If you set Enable AIM Output to on, the imager reads symbols with start/stop pattern 1 and
decodes them as standard full ASCII (start/stop pattern 1). If you set this parameter to off,
the imager reads symbols with start/stop pattern 1 and decodes them as compressed numeric
with optional full ASCII (start/stop pattern 2).
Minimum and Maximum Length
The length of a code refers to the number of characters (i.e., human readable characters), in-
cluding check digit(s). Double-tapping on these parameters displays a screen in which you
can set the minimum and maximum allowable code lengths – 1 to 60.
D.5.19 GS1 DataBar

GS1 DataBar

Set this parameter to on to enable the imager to read "GS1 Databar" symbols.
D-34 Psion Teklogix Omnii XT10 Hand-Held Computer User Manual