C.5.11 Interleaved 2 Of 5 - Psion Teklogix Omnii XT10 User Manual

Appendix C: Bar Code Settings
Non-Decoded Scanners
Interleaved 2 of 5
• Highlight the check digit you want to use, and tap on OK.
If this parameter set to One Check Digit, it is assumed that the last digit is a check digit.
If this parameter is set to Two Check Digits, it is assumed that the last two digits are check
digits.
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the decoded
symbol.
Length Restriction
Refer to "Length Restriction" on page C-14 for details.
Add/Remove Data
Refer to "Add/Remove Data" on page C-14 for details.

C.5.11 Interleaved 2 of 5

Enabled
Set this parameter to on to enable "Interleaved 2 of 5".
MOD 10 Check
If this parameter is enabled, the "MOD 10" check digit is calculated. This calculation is the
same as the Code 39 MOD 10 check digit.
ITF Check
If this parameter is enabled, the ITF-14/16 MOD 10 check digit is calculated.
Include Check
If this parameter is enabled, the check digit is included with the decoded bar code data.
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the decoded
symbol.
Length Restriction
Refer to "Length Restriction" on page C-14 for details.
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual C-63