Chapter 5: Configuration
Ports Tab
Enabled
This parameter must be set to ON in order for Omnii to recognize the device connected to
the Port Replicator 9-pin (COM5).
Baud
Double-tapping on this parameter displays a pop-up window in which you can choose an ap-
propriate rate of data transfer.
Figure 5.6 Port Baud Rates
Data Bits
This parameter determines the number of data bits included in each asynchronous data byte.
Most devices use 8-bit data bytes. Double-tapping on this option displays a pop-up window
in which you can choose either 7 or 8 data bits.
Parity
This parameter determines the type of parity checking used on the data going through the
port replicator port. Double-tapping on this option displays a pop-up window in which you
can choose the appropriate parity.
Stop Bits
This parameter specifies the number of stop bits—1, 1.5 or 2—used for asynchronous
communication.
158
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual