C.5.8 Codabar - Psion Teklogix Omnii XT10 User Manual

Appendix C: Bar Code Settings
Non-Decoded Scanners
Codabar
Convert to UPC-A
Setting this parameter to on results in a non-standard decoding that returns 12 digits from
the 6 digit UPC E bar code.
Include Number Sys
If this parameter is enabled, the number system digit is included with the decoded bar code
data.
Include Check
When enabled, the check digit is included with the decoded bar code data.
Addendum
Important: Before "Addendum" can take effect, the "Short Code" parameter (see
page C-55) must be enabled.
Refer to "Addendum" on page C-58.
Transmit Code ID Char
A code ID character identifies the scanned bar code type. In addition to any single character
prefix already selected, the code ID character is inserted between the prefix and the decoded
symbol.
Add/Remove Data
Refer to "Add/Remove Data" on page C-14 for details.
C.5.8 Codabar
Enabled
Set this parameter to on to enable "Codabar".
Strip Start/Stop Chars
Codabar uses the characters A, B, C, and D as start and stop characters. Thus, the first and
last digits of a Codabar message must be A, B, C, or D, and the body of the message should
not contain these characters. Setting this parameter to on strips the start and stop characters
from this bar code.
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual C-61