Indicators; Operation; Charging The Omnii Battery; Charging The Spare Battery - Psion Teklogix Omnii XT10 User Manual

6.7.2

Indicators

The front-mounted LED on the desktop docking station indicates the spare battery charge
status. The LED on Omnii is active even when the hand-held is inserted in a docking station
(and in suspend mode) so that the charge status of the battery can be detected easily.
Table 6.6 Docking Station Battery Charge LED Behaviour
Charge LED Behaviour
OFF
Solid Green
Flashing Green
Flashing Yellow
Solid Red
6.7.3

Operation

6.7.3.1 Charging the Omnii Battery

The desktop docking station supplies DC power to enable the Omnii internal fast charger.
When installed in the dock, the Omnii battery charge LED will illuminate to indicate the
unit has external power and can charge the internal battery. Omnii charge indication follows
the same convention as the charger's spare battery indicator (Figure 6.8).
Note: Battery charging continues whether Omnii is switched on or off.

6.7.3.2 Charging the Spare Battery

Important: Do not store spare batteries in a charger for more than 72 hours. Doing so
• Install the battery in the battery charge well (rear slot of the desktop docking station).
Place the battery contacts down to mate with the connector, and pivot the battery into
place in the battery charge well.
• The desktop docking station spare battery LED lights up immediately. During charge
the LED will be flashing green.
No battery detected.
Battery charging complete.
Charge in progress.
Battery is not charging due to out-of-temperature conditions.
Unable to read battery or non Psion Teklogix battery.
may damage the battery or reduce its charge capacity.
Chapter 6: Peripheral Devices & Accessories
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual
Function

Indicators

183