Carrying And Protective Accessories; Attaching The Hand Strap - Model No. St6025 - Psion Teklogix Omnii XT10 User Manual

6.4

Carrying and Protective Accessories

Note: Omnii Hand-Held Computer is a body worn device, and to maintain compliance with
the FCC RF exposure guidelines, use a Psion Teklogix approved carrying case. Use
of non-approved accessories may violate FCC RF exposure guidelines.
There are a variety of carrying and protective accessories to help the operator work safely
and comfortably with Omnii.
Attaching Carrying Accessories
If your Omnii is not fitted with a hand strap, you can install it using the carrying accessory
kit supplied. You'll need:
• A Phillips head screwdriver.
Important: Do not use adhesives such as Loctite to secure screws on carrying
Table 6.4 Accessories Model Numbers
Wrist Strap
Hand Strap
Shoulder Strap
Soft Shell Holster
Hard Shell Holster
Forklift Holster
Carrying Case
Pouch
Screen Protector
6.4.1

Attaching the Hand Strap - Model No. ST6025

• Attach the strap to the two threaded inserts located at the back of the hand-held near
the top of the unit (see Figure 6.2), using the two Phillips head screws provided with
this accessory.
accessories. These chemicals may damage the plastic casing.
Accessory
Chapter 6: Peripheral Devices & Accessories
Model Number
ST6040
ST6025
ST6030
ST6050
ST6055
ST6051
ST6090
ST6091
ST6112
Psion Teklogix Omnii XT10 Hand-Held Computer User Manual

Carrying and Protective Accessories

173