Setting The Hydrostatic Pump Neutral - Toro Z Master Z597 Service Manual

12. Install the rear heat shield and tighten the bolts (Fig.
198).
Fig 198
13. Close the engine hood and latch. Start unit up and
operate for approximately 5 minutes and check the
oil level in the reservoir.

Setting the Hydrostatic Pump Neutral

Note: Adjust handle neutral before setting pump
neutral. See Adjusting the Handle Neutral,
page 4-24.
This adjustment must be made with drive wheels turning.
Z Master Z597 Diesel Service Manual
HYDRAULIC SYSTEM
1. Raise the frame and support the machine so drive
wheels can rotate freely (Fig. 199).
DSC-2370
2. Slide the seat fully forward, unlatch the seat and tilt
the seat forward (Fig. 200).
Fig 199 DSC-2352
Fig 200 DSC-2357
4
4-23