Toro Z Master Z597 Service Manual page 72

6. Tilt the fan mounting plate assembly and the
radiator up approximately 5" (12.7cm) to get enough
clearance to remove the hydraulic motor fan.
Caution: Do not raise too far, as damage could
occur to some of the hydraulic lines and
cooling hoses.
Use a nylon tie down strap between the fan
mounting plate and the center section of the ROPS
Bar to hold in place (Fig. 182).
Fig 182
7. Place a small oil drain pan on top of the engine.
Loosen and remove the hydraulic lines to the
hydraulic fan motor (Fig. 183).
Fig 183
Z Master Z597 Diesel Service Manual
HYDRAULIC SYSTEM
8. Loosen and remove the 4 bolts and nuts holding the
fan motor mount (Fig. 184).
9. Remove the fan motor mount from the fan mounting
plate (Fig. 185).
DSC-2377
DSC-2378
Fig 184 DSC-2379
Fig 185 DSC-2380
4
4-19