Toro Z Master Z597 Service Manual page 59

HYDRAULIC SYSTEM
5. Install the hydraulic suction line on the top of the
hydrostatic pump (Fig. 135).
4
6. Install the two hydraulic hoses that run from
the hydraulic wheel motor to the bottom of the
hydrostatic pump (Fig. 136).
Remember to install the hydraulic hoses to the
correct port on the hydrostatic pump. If the lines are
reversed, the hydrostatic wheel motor will turn in the
direction opposite of motion control position.
Note: It may be easier to remove the rear tire
assembly for installation of the bottom and
side hydraulic hoses.
4-6
Fig 135 DSC-2088
Fig 136
DSC-2098
7. Install the case drain hydraulic line, located on the
left hand side of the pump (Fig. 137).
Fig 137
8. Install and tighten the bolt and nut retaining the
hydro pump control linkage to the hydro control arm
(Fig. 138).
Fig 138
Z Master Z597 Diesel Service Manual
DSC-2099
DSC-2081