Adjusting The Front-To-Rear Mower Pitch - Toro Z Master Z597 Service Manual

MOWER DECKS
7. If the measurement at positions B or C are not
correct, loosen the bolt attaching the rear chain
support arm (Fig. 559).
1. Rear chain
2. Rear support arm
3. Bolt
4. Jam nut
8. Loosen the jam nut under the rear support arm and
use the adjustment bolt to get a measurement of
3-1/8 to 3-1/4 inches (7.9 to 8.3cm).
Note: Ideally both sides of the mower are set to the
same distance.
9. Tighten the jam nut under the rear support arm and
tighten the bolt securing the chain to the rear support
arm.
7
7-48
Fig 559 fig. 67 m-6830
5. Adjustment bolt
6. Front swivel
7. Front support arm
Adjusting the Front-to-Rear Mower
Pitch
1. Position the right blade front-to-rear (Fig. 560).
Fig 560
2. Measure the right blade at the A location (Fig. 560),
from a level surface to the cutting edge of the blade
tip (Fig. 561).
MEASURE FROM CUTTING
EDGE TO A LEVEL SURFACE
Fig 561
Z Master 597 Diesel Series Service Manual
fig. 68 m-1078
fig. 69 m-2539