Setting The Lh Hydrostatic Pump Neutral - Toro Z Master Z597 Service Manual

7. Check where the control lever is relative to notch in
console (Fig. 203). It should be centered allowing
lever to pivot outward to the neutral lock position.
Fig 203
1. Neutral locked position
2. Control lever
8. If adjustment is needed, loosen the nut and jam nut
against the yoke (Fig. 202).
9. Apply slight rearward pressure on the motion
control lever, turn the head of the adjustment bolt
in the appropriate direction until the control lever is
centered in neutral lock position (Fig. 203).
Note: Keeping rearward pressure on the lever will
keep the pin at the end of the slot and allow
the adjustment bolt to move the lever to the
appropriate position.
10. Tighten the nut and jam nut (Fig. 202).
11. Repeat on the opposite side of the machine.
Z Master Z597 Diesel Service Manual
m-6282
3. Neutral position
HYDRAULIC SYSTEM
Setting the LH Hydrostatic Pump
Neutral
1. Start the engine, open throttle half way and release
parking brake.
Note: Motion control lever must be in neutral while
making any adjustments.
2. Adjust pump rod length by rotating the knob, in the
appropriate direction, until the wheel is still or slightly
creeping in reverse (Fig. 204).
A
Fig 204
A. Adjustment knob
3. Move motion control lever forward and reverse, then
back to neutral. Wheel must stop turning or creep
only slightly in reverse.
4. Open engine throttle to Fast. Make sure wheel
remains stopped or slightly creeps in reverse; adjust
if necessary.
4
DSC-2568
4-25