Replacing The Alternator Belt - Toro Z Master Z597 Service Manual

ENGINE

Replacing the Alternator Belt

1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operator
position.
3. Tilt the seat forward and remove the front engine
panel (Fig. 326)
5
4. Remove the hydrostatic pump drive belt. Refer to
Replacing the Traction Pump Drive Belt, page 4-31.
5-30
Fig 326 DSC-2071
5. Loosen the two bolts (top and bottom) holding the
alternator (Fig. 327).
Fig 327
6. Remove the belt from the pulleys and alternator.
7. Install a new belt around the pulleys and the
alternator (Fig. 328).
Fig 328
1. Alternator
2. Alternator belt
3. Handle
Z Master Z597 Diesel Service Manual
DSC-2584
fig 80 m-7421
4. Deflection, 3/8 to 1/2
inch (10 to 13mm)
5. Top bolt
6. Bottom bolt