Toro Z Master Z597 Service Manual page 42

2. Install the flange bearing over the left side of the
brake shaft, flange facing outward. Install mounting
bolts from the outside of the flange, through brake
retainer spacers, and through the frame.
Note: Before tightening the mounting hardware,
be sure that the brake lever arm is pointing
upward between the mounting hardware (Fig.
080).
A
B
C
Fig 080
A. Brake Lever Arm
B. Spacer
Z Master Z597 Diesel Service Manual
DSC-1641
C. Bolt
3. Install clevis pin connecting the lower brake
assembly to brake shaft. Install cotter pin into clevis
pin (Fig. 081). Repeat procedure for right side.
Fig 081
4. Install clevis spring pin connecting brake rod to
brake shaft. Rotate clevis spring pin until it clips onto
brake rod clevis (Fig. 082).
Fig 082
5. Install left and right rear tires. Torque wheel
mounting bolts to 95 ft-lbs (128.8 Nm).
CHASSIS
DSC-1643
DSC-1644
3-21
3