Adjusting The Handle Neutral - Toro Z Master Z597 Service Manual

HYDRAULIC SYSTEM
3. Disconnect the electrical connector from the seat
safety switch. Temporarily install a jumper wire
across terminals in the wiring harness connector
(Fig. 201).
4

Adjusting the Handle Neutral

If motion control levers do not align, or move easily into
the console notch, adjustment is required. Adjust each
lever, spring and rod separately.
Note: Motion control levers must be installed
correctly. See Installing the Motion Control
Levers in the Set Up instructions.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4-24
Fig 201 DSC-2355
3. Unlatch the seat and tilt the seat up.
4. Begin with either the left or right motion control lever.
5. Move lever to the neutral position but not locked
(Fig. 202).
Fig 202
1. Clevis pin in slot
2. Nut against yoke
3. Adjustment bolt
4. Pump rod
5. Double nuts
6. Jam nut
6. Pull lever back until the clevis pin (on arm below
pivot shaft) contacts the end of the slot (just
beginning to put pressure on the spring) (Fig. 202).
Z Master Z597 Diesel Service Manual
m-7510
7. Spring
8. Pivot shaft
9. Yoke
10. Locknut
11. Ball joint
12. Tracking knob