MOWER DECKS
20. Connect the electric PTO clutch harness to the
wiring harness (Fig. 554).
21. Pull the spring loaded idler bracket down and install
the fan pump drive belt (Fig. 555)
7
7-46
Fig 554
DSC-2601
Fig 555
DSC-2596
22. Install the mower spindle belt; refer to Mower
Spindle Belt, page 7-39.
23. Install the rear bumper and tighten the 4 bolts (Fig.
556).
Fig 556
Leveling the Mower
Setting up the Machine
1. Position mower on a flat surface.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Check the tire pressure of all four tires. If needed,
adjust to 13 psi (90 kPa).
Z Master 597 Diesel Series Service Manual
DSC-2595