Toro Z Master Z597 Service Manual page 71

HYDRAULIC SYSTEM
2. There are 6 bolts and nuts, 3 on each side, retaining
the radiator and fan mounting plate assembly to the
right and left upper frame assembly. Loosen, DO
NOT remove, the two bolts and nuts at the front
right and left side; this will allow you to pivot the
assembly upward. Remove the rear 4 bolts and nuts
(Fig. 178).
4
A. Remove
3. Remove the two knobs located on the engine access
panel assembly. Remove the engine belt shield and
the engine access panel (Fig. 179).
4-18
A
A
B
Fig 178 DSC-2371
B. Loosen
Fig 179
DSC-2071
4. Loosen and remove the clamp on the hydraulic
return line located on the left side of the unit (Fig.
180).
Fig 180
5. Remove the tie strap holding the throttle control
cable. Remove the clamps holding the inlet cooling
hose and the overflow hose to the radiator (Fig.
181).
Fig 181
Z Master Z597 Diesel Service Manual
DSC-2372
DSC-2374