Suzuki GSX1400 Service Manual page 114

3-74 ENGINE
• Install the cylinder head oil hose.
Cylinder head oil hose union bolt:
• Install the oil pipe with the white paint facing exhaust side.
• Install and tighten the oil pipe bolts with the washers.
Oil pipe bolt: 10 N . m (1.0 kgf . m, 7.4 lb-ft)
CAMSHAFT
• Turn the crankshaft clockwise with the box wrench and align
the "T" line on the signal generator rotor with the tip of the sig-
nal generator rotor sensor while keeping the cam chain pulled
upward.
Pull the cam chain upward, or the chain will be caught
between crankcase and cam drive sprocket.
• The camshafts are identified by the embossed letters.
NOTE:
Before installing the camshaft, check that the tappets are installed
correctly.
• Pull the cam chain lightly.
• Set the exhaust camshaft so that the arrow marked "1" is aligned
with the surface of the cylinder head.
• The other arrow marked "2" should now be pointing straight up.
Starting from the roller pin that is directly above the arrow
marked "2" , count out 24 roller pins.
• Engage the 24 roller pin on the cam chain with the arrow marked
"3" on the intake sprocket.
NOTE:
The cam chain should now be on all three sprockets. Be careful
not to move the crankshaft until the camshaft journal holders and
cam chain tension adjuster are secured.
www.GSX1400FE.com
20 N . m (2.0 kgf . m, 15 lb-ft)