Suzuki GSX1400 Service Manual page 105

• Confirm the gearshift cam stopper movement.
• Check the neutral position.
• Install the gearshift cam stopper plate after aligning the gear-
shift cam pin with the gearshift cam stopper plate hole.
• Apply a small quantity of THREAD LOCK to the gearshift cam
stopper plate bolt and tighten it to the specified torque.
99000-32050: THREAD LOCK "1342"
Gearshift cam stopper plate bolt: 10 N . m
• Install the gearshift shaft/gearshift arm with the washers as
shown.
NOTE:
Pinch the gearshift arm stopper with return spring ends.
• Install the washer and circlip.
OIL PUMP DRIVEN GEAR
• Install the washer 1 and the pin 2.
NOTE:
Be careful not to drop the washer and the pin into the crankcase.
• Install the oil pump driven gear 3.
• Install the circlip 4.
09900-06107: Snap ring pliers
CLUTCH
• Install the thrust washer 1 onto the countershaft.
NOTE:
The chamfer side of the thrust washer faces inner side.
• Install the needle bearing and spacer.
• Install the oil pump drive gear 2 to the primary driven gear
assembly.
www.GSX1400FE.com
(1.0 kgf . m, 7.4 lb-ft)
ENGINE 3-65