Suzuki GSX1400 Service Manual page 390

OPERATION
• When the ignition switch is turned ON with the engine stop switch in ON, the immobi-antenna and ECM
are powered ON.
The ECM transmits a signal to the transponder through the immobi-antenna in order to make comparison
between the key ID and ECM ID.
With the signal received, the transponder transmits the key ID signal to ECM so that ECM can make com-
parison with its own ID, and if it matches, the engine is made ready to start.
Also, when the ignition switch is turned ON, the indicator light
flashes as many as the number of IDs registered in ECM. There-
after, if the IDs are in agreement, the indicator light turns on for
two seconds to notify of completion in successful communica-
tion.
If the indicator light flashes fast, it notifies of communication
error or disagreement of ID.
NOTE:
If the indicator light flashes fast, turn the ignition switch OFF
then ON to make judgment again as there is possible misjudg-
ment due to environmental radio interference.
!
When the battery performance is lowered in winter
(low temperature), the system may at times makes a
re-judgment at the time of beginning the starter motor
operation. In this case, the indicator light operation
starts immediately after the starter operation.
www.GSX1400FE.com
Transponder
R O
Ignition switch
OFF
ON
GSX1400K5/UDK5 ('05-MODEL) 11-13
Immobi-antenna
ECM
Flashing
2 registered
3 registered
4 registered
Approx. 1.6 sec.
Lighting
Normal
Normal
Normal
Abnormal
Fast flashing
Approx. 2.0 sec.
Indicator light