Suzuki GSX1400 Service Manual page 288

7-16 ELECTRICAL SYSTEM
GEAR POSITION SWITCH
• Remove the left frame cover.
• Disconnect the gear position switch coupler and check the con-
tinuity between Blue and Black/White with the transmission in
"NEUTRAL".
When disconnecting and connecting the gear position
switch coupler, make sure to turn OFF the ignition switch,
or electronic parts may get damaged.
• Connect the gear position switch coupler to the wiring harness.
• Turn the ignition switch to "ON" position and side-stand to up-
right position.
Measure the voltage between Pink and Black/White lead wires
using a multi circuit tester, when shifting the gearshift lever from
low to top.
09900-25008: Multi circuit tester set
Tester knob indication: Voltage (
Gear position switch voltage: More than 0.6V
(
* Low to top gear position
* Except neutral position
NOTE:
* When connecting the multi circuit tester, install the copper wire
(O.D is below 0.5 mm) to the back side of the lead wire coupler
and connect the probes of tester to them.
* Use the copper wire, its outer diameter is below 0.5 mm, to
prevent the rubber of the water proof coupler from damage.
TURN SIGNAL/SIDE-STAND RELAY
The turn signal/side-stand relay is composed of the turn signal
relay, and the side-stand relay and diode.
• Remove the left frame cover.
• Remove the turn signal/side-stand relay.
www.GSX1400FE.com
)
)
(Pink – B/W)