Inspection And Disassembly - Suzuki GSX1400 Service Manual

6-46 CHASSIS

INSPECTION AND DISASSEMBLY

DUST SEAL AND SPACER
• Remove the dust seals 1, washers 2 and spacers 3 from
swingarm.
• Inspect the spacers for any flaws or other damage. If any de-
fects are found, replace the spacers with the new ones.
CHAIN BUFFER
• Remove the chain buffer.
• Inspect the chain buffer for wear and damage. If any defects
are found, replace the chain buffer with a new one.
SWINGARM BEARING
Insert the spacer into bearing and check the play when moving
the spacer up and down.
If excessive play is noted, replace the bearing with a new one.
• Remove the swingarm bearing and spacer with the special tools.
09941-64511: Bearing remover
09930-30102: Sliding shaft
Never reuse the removed bearings.
SWINGARM PIVOT SHAFT
Using a dial gauge, check the pivot shaft runout and replace it if
the runout exceeds the limit.
09900-20607: Dial gauge (1/100 mm, 10 mm)
09900-20701: Magnetic stand
09900-21304: V-block (100 mm)
Swingarm pivot shaft runout:
Service limit: 0.3 mm (0.01 in)
www.GSX1400FE.com