Suzuki GSX1400 Service Manual page 117

• After installing the cam chain tension adjuster, check to be sure
that the adjuster work properly by checking the slack of cam
chain.
• After installing the cam chain tension adjuster, rotate the crank-
shaft (some turns), and recheck the positions of the camshafts.
( 3-75)
• Install the cam chain guide.
Cam chain guide bolt: 10 N . m (1.0 kgf . m, 7.4 lb-ft)
SIGNAL GENERATOR COVER
• Apply SUZUKI BOND to the grommet and the crankcase mat-
ing surface.
99000-31140: SUZUKI BOND "1207B"
• Install the gasket.
• Install the signal generator cover.
Signal generator cover bolt: 11 N . m (1.1 kgf . m, 8.0 lb-ft)
NOTE:
Fit the gasket washer to the starter clutch cover bolt A as shown.
www.GSX1400FE.com
ENGINE 3-77