Suzuki GSX1400 Service Manual page 263

• Apply brake fluid to the piston/cup set.
• Install the following parts.
1 Piston/primary cup
2 Push rod
3 Circlip
4 Dust boot
• Apply the SUZUKI MOLY PASTE to the push rod.
99000-25140: SUZUKI MOLY PASTE
09900-06108: Snap ring pliers
• Install the master cylinder.
• Tighten the lock nut 2.
Rear master cylinder mounting bolt 1:
Rear master cylinder rod lock nut 2:
• Connect the brake hose to the master cylinder.
(Rear brake hose routing:
• Tighten the brake hose union bolt 3 to the specified torque.
Brake hose union bolt 3: 23 N . m (2.3 kgf . m, 16.5 lb-ft)
• Install the reservoir tank and reservoir tank hose.
(Rear brake hose routing :
* The seal washers should be replaced by the new ones
to prevent fluid leakage.
* Bleed air from the system after reassembling the mas-
ter cylinder. ( 2-22)
• Adjust the brake pedal height. (
INSPECTION AFTER REASSEMBLY
Rear brake: 2-19
www.GSX1400FE.com
10 N . m (1.0 kgf . m, 7.3 lb-ft)
18 N . m (1.8 kgf . m, 13.0 lb-ft)
8-23)
8-23)
2-20)
CHASSIS 6-63