BinTec RS120 Reference Manual page 67

bintec elmeg GmbH
bintec RS Series
receive your personal access data from your ISP. The terms used for the required access
data may vary from provider to provider, However, the type of information you need for dial-
in in is basically the same.
The following table lists the access data that your device also needs for a DSL connection
to the Internet.
Data for internet access over ADSL
Access data
Provider name
Protocol
Encapsulation
VPI (Virtual Path Identifier)
VCI (Virtual Circuit Identifier)
Your user name
Password
Some Internet Service Providers, such as T-Online, require additional information:
Additional information for T-Online
Access data
User account (12 digits)
T-Online number (usually 12 digits)
Joint user account
Note
To configure T-Online Internet access, enter the following succession of numbers
without intervening spaces in the User Name field: User account (12 digits) + T-Online
number (usually 12 digits) + co-user number (for the main user, always 0001). If your
T-Online number is less than 12 digits long, a "#" character is required between the T-
Online number and the co-user number. If you use T-DSL, you must add the character
string "@t-online.de" at the end of this string of numbers. You user name could, for ex-
ample, look like this: 00012345678906112345678#0001@t-online.de
Internet access over UMTS/LTE
The following table lists the access data that you need for an internet connection over
UMTS/LTE.
Example value
Example value
4 Basic configuration
Your values
Your values
53