BinTec RS120 Reference Manual page 471

bintec elmeg GmbH
bintec RS Series
Field
Interface
Domain at the HotSpot
Server
Walled Garden
Walled Network / Net-
mask
Walled Garden URL
Description
Choose the interface to which the Hotspot LAN or WLAN is con-
nected. When operating over LAN, enter the Ethernet interface
here (e. g. en1-0). If operating over WLAN, the WLAN interface
to which the access point is connected must be selected.
Caution
For security reasons you cannot configure your device over
an interface that is configured for the Hotspot. Therefore
take care when selecting the interface you want to use for
the Hotspot.
If you select the interface over which the current configura-
tion session is running, the current connection will be lost.
You must then log in again over a reachable interface that
is not configured for the Hotspot to configure your device.
Enter the domain name that you used when setting up the Hot-
Spot server for this customer. The domain name is required so
that the Hotspot server can distinguish between the different cli-
ents (customers).
Enable this function if you want to define a limited and free area
of websites (intranet).
The function is not activated by default.
Only if Walled Garden is enabled.
Enter the network address of the Walled Network and the cor-
responding Netmask of the intranet server.
For the address range resulting from Walled Network / Net-
mask, clients require no authentication.
Example: Enter 192.168.0.0 / 255.255.255.0, if all IP addresses
from 192.168.0.0 to 19.168.0.255 are free. Enter 192.168.0.1 /
255.255.255.255, if only the IP address 192.168.0.1 is free.
Only if Walled Garden is enabled.
Enter the Walled Garden URL of the intranet server. Freely ac-
cessible websites must be reachable over this address.
18 Local Services
457