BinTec RS120 Reference Manual page 52

3 Installation
38
Fig. 20: Arrangement of LEDs
In operation mode, the LEDs display the following status information for your device:
LED status display
LED Colour
POWER green
STATUS green
green
green
Ethernet 1 to green
4: LINK/ACT
green
Ethernet 1 to green
4: SPEED
orange
Ethernet 5: green
LINK/ACT
green
Ethernet 5: green
SPEED
orange
ADSL green
Status Information
on The power supply is connected.
off No power supply.
on After switching on: The device has started.
During operation: An error has occurred.
flashing The device is active.
off During operation: An error has occurred.
on The connection to the LAN has been estab-
lished.
flashing Data traffic via the LAN interface.
off No connector.
on The device is connected to the LAN at 1000
mbps.
on The device is connected to the LAN at 100
mbps.
off The device is connected to the LAN at 10
mbps or there is no data traffic.
on The connection to the WAN has been estab-
lished.
flashing Data traffic via the WAN interface.
off No connector.
on The device is connected to the WAN at
1000 mbps.
on The device is connected to the WAN at 100
mbps.
off The device is connected to the LAN at 10
mbps or there is no data traffic.
on DSL connection is active.
bintec elmeg GmbH
bintec RS Series