BinTec RS120 Reference Manual page 305

Table of Contents

bintec elmeg GmbH

bintec RS Series

IP Assignment Pool

The menu Advanced Settings consists of the following fields:

Fields in the Advanced Settings menu.

Block after connection

Maximum Number of

Dialup Retries

Authentication

Only if IP Address Mode =

Select IP pools configured in the WAN->Internet + Dialup->IP

Poolsmenu. If an IP pool has not been configured here yet, the

Enter the wait time in seconds before the device should try

again after an attempt to set up a connection has failed.

The default value is

Enter the number of unsuccessful attempts to setup a connec-

tion before the interface is blocked.

Possible values are

The default value is .

If necessary, select a special interface use.

Possible values:

(default value): No special type is selected.

: The interface is used for incoming dialup con-

nections and callbacks initiated externally.

multi-user connection partner, i.e. several clients dial in with

the same user name and password.

Select the authentication protocol for this PPTP partner.

Possible values:

(default value): Only run PAP (PPP Password Authentic-

ation Protocol); the password is transferred unencrypted.

: Only run CHAP (PPP Challenge Handshake Authentic-

ation Protocol as per RFC 1994); password is transferred en-

appears in this field.

: The interface is defined as

Show Quick Links

Table of Contents