BinTec RS120 Reference Manual page 341

bintec elmeg GmbH
bintec RS Series
Field
Public Interface Mode
Public Source IP Ad-
dress
Back Route Verify
MobIKE
Proxy ARP
Description
setting under Public Interface Mode.
Specify how strictly the setting under Public Interface is
handled. Possible values:
• : Only the selected interface is used, whatever the
priorities in the current routing table.
• : Depending on the priorities in the current routing
table, the selected interface is used if no more favourable
route is available via a different interface.
If you are operating more than one Internet connection in paral-
lel, here you can specify the public IP address that is to be used
as the source address for the peer's data traffic. Select whether
the Public Source IP Address is to be enabled.
The function is enabled with
In the input field, enter the public IP address that is to be used
as the sender address.
The function is disabled by default.
Select whether a check on the back route should be activated
for the interface to the connection partner.
The function is enabled with
The function is disabled by default.
Only for peers with IKEv2.
MobIKE In cases of changing public IP addresses, enables only
these addresses to be updated in the SAs without the SAs
themselves having to be renegotiated.
The function is enabled by default.
Note that MobIKE requires a current IPSec client, e. g. the cur-
rent Windows 7 or Windows 8 client or the latest version of the
bintec elmeg IPSec client.
Select whether your device is to respond to ARP requests from
its own LAN on behalf of the specific connection partner.
Possible values:
.
.
15 VPN
327