BinTec RS120 Reference Manual page 40

3 Installation
26
• DMZ
Connect the WAN interface ( ETH, white connector) of your device to the Ethernet con-
nection of your DMZ via another Ethernet cable.
• Other LANs/WANs
Connect any other terminals in your network to the remaining switch ports (2, 3 or 4) of
your device using other Ethernet cables.
• USB
Connect a wireless flash drive to the USB port on your device.
• Serial connection
For alternative configuration options, connect the serial interface of your PC with the seri-
al interface of the device (Console). However, configuration via the serial interface is not
provided by default. A suitable cable is available as an accessory.
The device is now ready for configuration with the GUI. Chapter
page 50 provides a detailed step-by-step guide to the basic functions on your device.
Installation
The access points can be fitted to the wall using brackets or can used as a table-top
device.
Use as a table-top device
Attach the four self-adhesive feet on the bottom of the device. Place your device on a solid,
level base.
Wallmounting
To attach the devices bintec RS230x to the wall, use the brackets on the back of the hous-
ing.
Warning
Before drilling, make sure that there are no building installations where you are drilling.
If gas, electricity, water or waste water lines are damaged, you may endanger your life
or damage property.
Kensington Lock
The devicesoffer the option to fit a Kensington Lock. The opening required for this can be
found on the right side of the housing.
bintec elmeg GmbH
Basic configuration on
bintec RS Series