BinTec RS120 Reference Manual page 21

bintec elmeg GmbH
bintec RS Series
equipped with two external LTE UMTS antennas and one external GPS antenna.
Fig. 2: Connection options using the example of
When setting up and connecting, carry out the steps in the following sequence:
(1) Antennas
Screw the external WLAN antennas (only bintec RS353jw) supplied to the connec-
tions provided for this purpose. With bintec RS353j-4G screw the two external
UMTS antenna and the GPS antenna to the connections provided.
(2) ETH1-4
Connect the first switch port (ETH1, yellow connector) your device through the sup-
plied Ethernet cable to your LAN to configure the device. The device automatically
detects whether It is connected to a switch or directly to a PC. Connect more
devices, LANs or WANs to the Port ETH1 up ETH4 on.
(3) VDSL
Connect the VDSL interface (VDSL, grey connector) of your device to the DSL out-
put of the splitter using the DSL cable (grey cable) supplied.
(4) Power connection
Connect the POWER interface of your device via the supplied power cord to your
power supply.
You can set up further connections as required:
• ETH5
bintec RS353j-4G
3 Installation
7