BinTec RS120 Reference Manual page 43

bintec elmeg GmbH
bintec RS Series
LED Colour
Ethernet 1 to green
4: SPEED
orange
Ethernet 5: green
LINK/ACT
green
Ethernet 5: green
SPEED
orange
ADSL green
WLAN (only green
bintec
RS230aw )
USB green
UMTS (only green
bintec
RS230aw )
You can determine the status of the router in BRRP operation with the aid of the status
LED.
Status Information
on The device is connected to the LAN at 1000
mbps.
on The device is connected to the LAN at 100
mbps.
off The device is connected to the LAN at 10
mbps or there is no data traffic.
on The connection to the WAN has been estab-
lished.
flashing Data traffic via the WAN interface.
off No connector.
on The device is connected to the WAN at
1000 mbps.
on The device is connected to the WAN at 100
mbps.
off The device is connected to the LAN at 10
mbps or there is no data traffic.
on DSL connection is active.
off No connector.
flashing Data traffic via the DSL interface.
on The wireless module is active.
off No connector to wireless module.
flashing Data traffic via the WLAN interface.
on USB connection is active.
off No connector.
flashing Data traffic via the USB interface.
on UMTS/LTE connection is active.
off No connector.
flashing Data traffic over UMTS/LTE.
3 Installation
29