BinTec RS120 Reference Manual page 22

3 Installation
8
Connect the ETH5 interface (white connector) of your device via a RJ45 cable to your
LAN/WAN interface.
• BRI
Connect the BRI interface (black connector) of the device to your ISDN socket using the
ISDN BRI cable provided.
• USB
Connect a wireless flash drive to the USB port on your device.
• USB CONSOLE
For alternative configurations, connect the USB console type B of your device via a USB
cable to the PC. A suitable cable is available as an accessory.
The device is now ready for configuration with the GUI. Chapter
page 50 provides a detailed step-by-step guide to the basic functions on your device.
Installation
The devices are optionally equipped with straps in the housing on the wall, as a table top
unit or for installation in 19 inch cabinet.
Use as a table-top device
Attach the four self-adhesive feet on the bottom of the device. Place your device on a solid,
level base.
The 19- inch cabinet installation
Screw your device using the supplied brackets and screws into the cabinet.
Wallmounting
To attach the bintec RS353x series on the wall, use the tabs on the back side of the hous-
ing.
Warning
Before drilling, make sure that there are no building installations where you are drilling.
If gas, electricity, water or waste water lines are damaged, you may endanger your life
or damage property.
Kensington Lock
The devices offer the possibility of a Kensington lock to secure. You will find the required
bintec elmeg GmbH
Basic configuration on
bintec RS Series