BinTec RS120 Reference Manual page 230

11 Networking
216
Field
Original Source Port/
Range
Source Port/Range
Destination IP Ad-
dress/Netmask
Destination Port/Range Only for Type of traffic =
In the NAT Configuration ->Replacement Values menu you can define, depending on
whether you're dealing with inbound or outbound data traffic, new addresses and ports, to
which specific addresses and ports from the NAT Configuration ->Specify original traffic
menu can be translated.
Fields in the menu Replacement Values
Field
New Destination IP Ad- Only for Type of traffic =
Description
Only for Type of traffic =
method = , Service =
tocol = , ,
Enter the source port of the original data packets. The default
setting means that the port remains unspecified.
If you select
you select
ous range of ports which will be a applied for filtering the outgo-
ing data traffic
Only for Type of traffic =
vice = and Protocol =
Enter the source port or the source port range of the original
data packets. The default setting
mains unspecified.
Only for Type of traffic =
Enter the destination IP address and corresponding netmask of
the original data packets, as the case arises.
method = , Service =
tocol = , ,
, Service =
, ,
Enter the destination port or the destination port range of the
original data packets. The default setting
port remains unspecified.
Description
bintec elmeg GmbH
and Pro-
you can specify a single port, if
you can specify a continu-
, ,
means that the port re-
and NAT method =
and Pro-
or Type of traffic =
and Protocol =
means that the
, NAT
, Ser-
or
, NAT
bintec RS Series