BinTec RS120 Reference Manual page 49

bintec elmeg GmbH
bintec RS Series
connection diagrams for the individual devices in chapter on page ):
(1) Antennas
Screw the external WLAN antennas ( bintec RS232jw ) supplied to the RSMA con-
nections provided for this purpose. With bintec RS232j-4G screw the two UMTS/
LTE antenna to the SMA connections.
(2) Place your device on a solid, level base.
(3) LAN
For the standard configuration of your device via Ethernet, connect the first switch
port (1, yellow connector) of your device to your LAN using the Ethernet cable
(yellow cable) supplied. The device automatically detects whether it is connected to
a switch or directly to a PC.
(4) ADSL
Connect the ADSL interface (ADSL, grey connector) of your device to the DSL out-
put of the splitter using the DSL cable (grey cable) supplied.
(5) Mains connection
Connect the device to a mains socket using the mains device supplied.
You can set up further connections as required:
• ISDN
Connect the ISDN interface (BRI, black connector) of the device to your ISDN socket us-
ing the ISDN cable (black cable) provided.
• DMZ
Connect the WAN interface ( ETH, white connector) of your device to the Ethernet con-
nection of your DMZ via another Ethernet cable.
• Other LANs/WANs
Connect any other terminals in your network to the remaining switch ports (2, 3 or 4) of
your device using other Ethernet cables.
• Serial connection
For alternative configuration options, connect the serial interface of your PC with the seri-
al interface of the device (Console). However, configuration via the serial interface is not
provided by default. A suitable cable is available as an accessory.
The device is now ready for configuration with the GUI. Chapter
page 50 provides a detailed step-by-step guide to the basic functions on your device.
Installation
The access points can be fitted to the wall using brackets or can used as a table-top
3 Installation
Basic configuration on
35