BinTec RS120 Reference Manual page 345

bintec elmeg GmbH
bintec RS Series
Field
Mode
Incoming Phone Num-
ber
Outgoing Phone Num-
ber
Transfer own IP ad-
dress over ISDN/GSM
Transfer Mode
Description
Select the Callback Mode.
Possible values:
• (default value): IPSec callback is deactivated. The
local device neither reacts to incoming ISDN calls nor initiates
ISDN calls to the remote device.
• : The local device only reacts to incoming ISDN calls
and, if necessary, initiates setting up an IPSec tunnel to the
peer. No ISDN calls are sent to the remote device to cause
this to set up an IPSec tunnel.
• : The local device sends an ISDN call to the remote
device to cause this to set up an IPSec tunnel. The device
does not react to incoming ISDN calls.
• : Your device can react to incoming ISDN calls and send
ISDN calls to the remote device. The setting up of an IPSec
tunnel is executed (after an incoming ISDN call) and initiated
(by an outgoing ISDN call).
Only for Mode =
Enter the ISDN number from which the remote device calls the
local device (calling party number). Wildcards may also be
used.
Only for Mode =
Enter the ISDN number with which the local device calls the re-
mote device calls (called party number). Wildcards may also be
used.
Select whether the IP address of your own device is to be trans-
ferred over ISDN for IPSec callback.
The function is enabled with
The function is disabled by default.
Only for Transfer own IP address over ISDN/GSM = enabled
Select the mode in which your device is to attempt to transfer its
IP address to the peer.
or
or
.
15 VPN
331