Table of Contents
Advertisement
14 WAN
290
Field
IP Address Mode
Default Route
Create NAT Policy
Local IP Address
Route Entries
Description
Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
•
(default value): You enter a static IP address.
•
IP address to the remote terminal.
•
: Your device is dynamically assigned an
IP address.
Only for IP Address Mode =
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with
The function is disabled by default.
Only for IP Address Mode =
When you configure an ISDN Internet connection, specify
whether Network Address Translation (NAT) is to be activated.
The function is enabled with
The function is disabled by default.
Only if IP Address Mode =
Assign the IP address from your LAN to the ISDN interface
which is to be used as your device's internal source address.
Only if IP Address Mode =
Define other routing entries for this connection partner.
•
: IP address of the destination host or
network.
•
: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
•
: The lower the value, the higher the priority of the
route (range of values ...
bintec elmeg GmbH
: Your device dynamically assigns an
and
.
and
.
). The default value is .
bintec RS Series
Hide quick links:
Advertisement
Table of Contents
