BinTec RS120 Reference Manual page 127

bintec elmeg GmbH
bintec RS Series
Field
Alive Check
Retries
RADIUS Dialout
Value
The default value is
Here you can activate a check of the accessibility of a RADIUS
server in Status .
An Alive Check is carried out regularly (every 20 seconds) by
sending an ACCESS_REQUEST to the IP address of the RADI-
US server. If the server is reachable, Status is set to
again. If the RADIUS server is only reachable over a
switched line (dialup connection), this can cause additional
costs if the server is
The function is activated by selecting
The function is enabled by default.
Enter the number of retries for cases when there is no response
to a request. If an response has still not been received after
these attempts, the Status is set to
your device attempts to reach the server every 20
seconds. If the server responds, Status is set back to
Possible values are whole numbers between
The default value is . To prevent Status being set to
this value to .
Only for Authentication Type =
Select whether your device receives requests from RADIUS
server dialout routes. This enables temporary interfaces to be
configured automatically and your device can initiate outgoing
connections that are not configured permanently.
The function is activated by selecting
The function is disabled by default.
If the function is active, you can enter the following options:
• : Enter the time period in seconds
between update intervals.
The default entry here is
7 System Management
(1 second).
for a long time.
.
. In Alive Check =
and
.
.
i.e. an automatic reload is not car-
.
.
, set
and
113