BinTec RS120 Reference Manual page 393

Table of Contents

bintec elmeg GmbH

bintec RS Series

Select the action to be applied to a filtered packet.

Possible values:

(default value): The packets are forwarded on the

basis of the entries.

: The packets are rejected.

: The packets are rejected. An error message is is-

sued to the sender of the packet.

Only for Action =

Select whether you want to enable QoS for this policy with the

priority selected in Priority.

The function is enabled with

The option is deactivated by default.

If QoS is not activated for this policy, bear in mind that the data

cannot be prioritised on the sender side either.

A policy for which QoS has been enabled is also set for the fire-

wall. Make sure therefore that data traffic that has not been ex-

pressly authorised if blocked by the firewall!

Only for Action =

Select the priority with which the data specified by the policy is

handled on the send side.

Possible values:

(default value): No priority.

: Low Latency Transmission (LTT), i.e. hand-

ling of data with the lowest possible latency, e.g. suitable for

and Apply QoS =

Show Quick Links

Table of Contents