Table of Contents
Advertisement
bintec elmeg GmbH
bintec RS Series
Field
Local IP Address
Route Entries
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field
Block after connection
failure for
Maximum Number of
Dialup Retries
Authentication
Description
The function is enabled by default.
Only if IP Address Mode =
Enter the static IP address of the connection partner.
Only if IP Address Mode =
Define other routing entries for this connection partner.
Add new entries with Add.
•
: IP address of the destination host or
network.
•
: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
•
: The lower the value, the higher the priority of the
route (range of values ...
Description
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed. The de-
fault value is
.
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
Possible values are
to
The default value is .
Select the authentication protocol for this connection partner.
Select the authentication specified by your provider.
Possible values:
•
(default value): Only run PAP (PPP Password Authentic-
ation Protocol); the password is transferred unencrypted.
•
: Only run CHAP (PPP Challenge Handshake Authentic-
ation Protocol as per RFC 1994); password is transferred en-
). The default value is .
.
14 WAN
275
Hide quick links:
Advertisement
Table of Contents
