Quick Setup - Printronix T5204R Administrator's Manual

QUICK SETUP

QUICK
SETUP
(from page 84)
Print Print
Intensity Speed
-3* 6 ips*
-15 to 15 1 ips to 10 ips
Label
Width
2, 4
4.1, 6.6, or 8.5 inches*
4
00.1 to 8.5 inches
Auto Calibrate Validator
Funct.
Run Calibrate Enable*
Disable
Notes:
* = Factory Default
1
Maximum value depends on the printer model width (4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to millimeters under Units (in MEDIA CONTROL) when Admin User is
enabled.
3
Based on the current value setting for the Label Length (in QUICK SETUP), up to a maximum of 12.80 inches.
4
Maximum value depends on the width of the printer model (see Appendix A, "Specifications").
5
Gap/Mark Sensor and Paper Out Sensor work in conjunction, as shown in Table 6 on page 127. If you change
the Gap/Mark Sensor or Paper Out Sensor, you must recalibrate the media.
6
Appears only if a validator is installed.
7
This menu will not appear on Direct Thermal only printers.
8
xxx represents the emulation name selected in the Active IGP Emul menu. The options in this menu vary and are
described on page 140.
Print Media
7
Mode Handling
Transfer* Tear-Off Strip*
1
Direct Tear-Off
Peel-Off
Cut
Continuous
Ver Image Hor Image
Shift Shift
2
0.00 inches 0.00 inches*
3
-1.00 to X inches -1.00 to 1.00 inches
Active IGP
6
Emul Diagnostics
PGL* See footnote 8.
ZGL
TGL
IGL
STGL
DGL
IEGL
MGL
VGL
Paper Feed
Shift
2
0.00 inches*
3
-1.00 to X inches
Orientation
2
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
xxx Save Config.
8
1*
1-8
Label
Length
2, 4
4 or 6 inches*
4
00.1 to 99.0 inches
Gap/Mark
5
Sensor
Disable
Mark
Gap
Advanced Gap*
Advanced Notch
Power-Up
Config.
Factory*
1-8
95